Amer Networks E5Web GUI - Manual (Page 744)

12.10. Miscellaneous Settings
UDP Source Port 0
How to treat UDP packets with source port 0.
Default: DropLog
Port 0
How to treat TCP/UDP packets with destination port 0 and TCP packets with source port 0.
Default: DropLog
Watchdog Time
Number of non-responsive seconds before watchdog is triggered (0=disable).
Default: 180
Flood Reboot Time
As a final way out, cOS Core automatically reboots if its buffers have been flooded for a long
time. This setting specifies the amount of time the buffers are flooded before the reboot occurs.
Default: 3600
Dynamic High Buffers
This setting decides if cOS Core will automatically specify the High Buffers value. The default
value is 3% of total available memory, with a lower limit of 1024
Note that in addition to this there is always an extra 512 Kbytes allocated for buffers.
This setting requires a cOS Core restart for a new value to take effect. A reconfiguration is not
sufficient.
Default: Enabled
High Buffers
If Dynamic High Buffers is not enabled then this number of buffers will be allocated in RAM
above the 1 MByte limit. When troubleshooting problems, raising this value can sometimes
provide a solution.
This setting requires a cOS Core restart, for example using the shutdown command, for a new
value to take effect. A reconfiguration is not sufficient.
Default: 1024
Important: Setting high buffers is not recommended
Enabling the setting Dynamic High Buffers is recommended for most configurations.
Rarely, cOS Core support personnel might recommend disabling it and specifying a fixed
Chapter 12: Advanced Settings
744