Amer Networks E5Web GUI - Manual (Page 100)

InControl
Follow the same steps used for the Web Interface below.
Web Interface
1. Go to: System > Device > Remote Management > Add > SNMP management
2. For Remote access type enter:
• Name: a suitable name, for example snmp_access
• Community: Mg1RQqR
3. For Access Filter enter:
• Interface: lan
• Network: mgmt-net
4. Click OK
Should it be necessary to enable SNMP Before Rules (which is enabled by default) then the
setting can be found in System > Device > Remote Management > Advanced Settings.
SNMP Advanced Settings
The following SNMP advanced settings can be found under the Remote Management section in
the Web Interface or InControl. They can also be set through the CLI.
SNMP Before RulesLimit
Enable SNMP traffic to the security gateway regardless of configured IP Rules.
Default: Enabled
SNMP Request Limit
Maximum number of SNMP requests that will be processed each second by cOS Core. Should
SNMP requests exceed this rate then the excess requests will be ignored by cOS Core.
Default: 100
System Contact
The contact person for the managed node.
Default: N/A
System Name
The name for the managed node.
Chapter 2: Management and Maintenance
100