Amer Networks E5Web GUI User Manual
Page 632
Assume the same scenario as the previous example, but this time the L2TPv3 tunnel is itself
being tunneled through an IPsec Tunnel object called my_ipsec_tunnel.
Setup of the IPsec tunnel is not shown in this example but follows the same setup described in
Section 9.5.2, “L2TP Servers”.
Command-Line Interface
A. First, define the L2TPv3 Server object:
Device:/> add Interface L2TPv3Server my_l2tpv3_if
IP=If3_ip
LocalNetwork=If3_net
Interface=my_ipsec_tunnel
ServerIP=If2_ip
B. Next, enable transparent mode on the protected interface If3:
Device:/> Set Interface Ethernet If3 AutoSwitchRoute=Yes
InControl
Follow the same steps used for the Web Interface below.
Web Interface
A. First, define an L2TPv3 Server object:
1.
Go to: Network > Interfaces and VPN > L2TPv3 Servers > Add > L2TPv3 Server
2.
Now enter:
•
Name: my_l2tpv3_if
•
Inner IP Address: If3_ip
•
Local Network: If3_net
•
Outer Interface Filter: my_ipsec_tunnel
•
Server IP: If2_ip
3.
Click OK
B. Next, enable transparent mode on the protected interface If3:
1.
Go to: Network > Interfaces and VPN > Ethernet
2.
Select the If3 interface
3.
Select the option Enable transparent mode
4.
Click OK
Setup With VLANs
Chapter 9: VPN
632