beautypg.com

Advanced settings for transparent mode – Amer Networks E5Web GUI User Manual

Page 355

background image

Drop/Log - Drop all MPLS packets without verification and log these drops.

4.8.6. Advanced Settings for Transparent Mode

CAM To L3 Cache Dest Learning

Enable this if the security gateway should be able to learn the destination for hosts by combining
destination address information and information found in the CAM table.

Default: Enabled

Decrement TTL

Enable this if the TTL should be decremented each time a packet traverses the security gateway
in transparent mode.

Default: Disabled

Dynamic CAM Size

This setting can be used to manually configure the size of the CAM table. Normally Dynamic is
the preferred value to use.

Default: Dynamic

CAM Size

If the Dynamic CAM Size setting is not enabled then this is the maximum number of entries in
each CAM table.

Default: 8192

Dynamic L3C Size

Allocate the L3 Cache Size value dynamically.

Default: Enabled

L3 Cache Size

This setting is used to manually configure the size of the Layer 3 Cache. Enabling Dynamic L3C
Size
is normally preferred.

Default: Dynamic

Transparency ATS Expire

Defines the lifetime of an unanswered ARP Transaction State (ATS) entry in seconds. Valid values
are 1-60 seconds.

Default: 3 seconds

Chapter 4: Routing

355

This manual is related to the following products: