Amer Networks E5Web GUI - Manual (Page 323)

Command-Line Interface
First, change the CLI context to be the DynamicRoutingRule just added for export:
Device:/> cc DynamicRoutingRule ExportDefRoute
Next, add a DynamicRoutingRuleExportOSPF object:
Device:/2(ExportDefRoute)> add DynamicRoutingRuleExportOSPF
ExportToProcess=as_0
InControl
Follow the same steps used for the Web Interface below.
Web Interface
1. Go to: Network > Routing > Routing Rules
2. Click on the newly created ExportAllNets
3. Go to: OSPF Actions > Add > DynamicRoutingRuleExportOSPF
4. For Export to process choose as_0
5. Click OK
The same procedure should be repeated for security gateway B.
4.6.7. OSPF Troubleshooting
There are two special ways of troubleshooting OSPF issues:
• Additional OSPF Log Event Messages.
• The OSPF CLI command.
These are discussed next.
Additional OSPF Log Event Messages
By default, a range of basic log event messages are generated by OSPF operation within cOS
Core. For example, if the OSPFProcess object running under cOS Core is called my_ospf_proc,
normal log generation would be enabled with the CLI command:
Device:/> set OSPFProcess my_ospf_proc LogEnabled=Yes
This is the default setting so the command is only for illustration.
The following properties can be enabled to provide additional OSPF log messages for
troubleshooting and/or monitoring purposes:
• DebugPacket - Log general packet parsing events.
• DebugHello - Log Hello packets.
Chapter 4: Routing
323