An ospf example, Creating an ospf router process – Amer Networks E5Web GUI User Manual
Page 318
4.6.6. An OSPF Example
This section goes through the detailed setup steps for the simple OSPF scenario illustrated
below.
Figure 4.19. An OSPF Example
Here, two identical Clavister Security Gateways called A and B are joined together directly via
their If3 interfaces. Each has a network of hosts attached to its If1 interface. On one side, If1_net
is the IPv4 network 10.4.0.0/16 and on the other side it is the IPv4 network 192.168.0.0/24.
The goal is to configure OSPF on both security gateways so routing information is automatically
exchanged and traffic can be correctly routed between the 10.4.0.0/16 network and the
192.168.0.0/24 network. The IP rules that are needed to allow such traffic to flow are not included
in this example.
Example 4.9. Creating an OSPF Router Process
First the Autonomous System (AS) must be defined on both security gateways.
On security gateway A, create an OSPF Router Process object. Assume the object name will be
as_0.
Command-Line Interface
Device:/> add OSPFProcess as_0
InControl
Chapter 4: Routing
318