Amer Networks E5Web GUI - Manual (Page 331)

The following SAT Multiplex rule needs to be configured to match the scenario described above:
InControl
Follow the same steps used for the Web Interface below.
Web Interface
A. Create a custom service for multicast called multicast_service:
1. Go to: Objects > Services > Add > TCP/UDP
2. Now enter:
• Name: multicast_service
• Type: UDP
• Destination: 1234
B. Create an IP rule:
1. Go to: Policies > Add > IP Rule
2. Under General enter.
• Name: a name for the rule, for example Multicast_Multiplex
• Action: Multiplex SAT
• Service: multicast_service
3. Under Address Filter enter:
• Source Interface: wan
• Source Network: 192.168.10.1
• Destination Interface: core
• Destination Network: 239.192.10.0/24
4. Click the Multiplex SAT tab
5. Add interface if1 but leave the IPAddress empty
6. Add interface if2 but this time, enter 237.192.10.0 as the IPAddress
7. Enable the option:
Multicast traffic must have been requested using IGMP before it is forwarded
8. Click OK
Note: Replace Allow with NAT for source IP translation
If address translation of the source address is required, the Allow rule following the SAT
Multiplex rule should be replaced with a NAT rule.
Chapter 4: Routing
331