beautypg.com

Changing a remote access rule – Amer Networks E5Web GUI User Manual

Page 63

background image

4.

Set the following:

IP address: 192.168.1.2

5.

Click OK

Note: In virtualized configurations, interfaces addresses are stored in the top level of the address
book and not in an address book folder called InterfaceAddresses.

Changing a Remote Access Rule

If the network as well as the IP address changes for a management interface, and/or a different
interface is used, then the relevant management access rule will also need to be changed as
shown in the example below.

Example 2.6. Changing a Remote Access Rule

This example will change the current rule for HTTP and HTTPS management access to allow
access on the If2 interface and from the network defined by the address book object
management_net which is already defined.

Command-Line Interface

Device:/> set RemoteManagement RemoteMgmtHTTP rmgmt_http

Network=management_net
Interface=If2

Web Interface

1.

Go to: System > Device > Remote Management > rmgmt_http

2.

Set the following:

Interface: If2

Network: management_net

3.

Click OK

HA Cluster Management IPs Must Be Different

In a cOS Core high availability cluster, the management IPs should always be different on the
master and slave units for their management interfaces. The shared IP address cannot be used
for cOS Core management.

The individual IPv4 addresses for the management interface of the cluster master and slave units
are held in the IP4 HA Address object for that interface and this is duplicated on both master and
slave units. If the management interface IP in this address object is changed on one unit it will be
automatically copied over to the other unit by the synchronization process.

Chapter 2: Management and Maintenance

63

This manual is related to the following products: