beautypg.com

Add ospf interface objects – Amer Networks E5Web GUI User Manual

Page 320

background image

5.

Click OK

Now, repeat this for security gateway B, using the same OSPF Area object name of area_0.

Example 4.11. Add OSPF Interface Objects

For security gateway A, add OSPF Interface objects for each physical interface that is to be part of
the OSPF area called area_0.

Command-Line Interface

Assume the context is still the OSPFProcess called as_0 from the last example. Now, change the
context to be the OSPFArea that was created previously:

Device:/as_0> cc area_0

Next, add the OSPFInterface object:

Device:/as_0/area_0> add OSPFInterface If1 Passive=Yes

Enabling the Passive option means that this interface is not connected to another OSPF router.
Finally, return to the default CLI context:

Device:/as_0/area_0> cc
Device:/>

InControl

Follow the same steps used for the Web Interface below.

Web Interface

1.

Go to: Network > Routing > OSPF > as_0 > area_0 > OSPF Interfaces

2.

Select Add > OSPF Interface

3.

Select the Interface. In this case, If1

4.

Select the Advanced tab

5.

Select No OSPF routers connected to this interface

6.

Click OK

Just selecting the Interface means that the Network defaults to the network bound to that
interface. In this case If1_net.

This should be repeated for all interfaces that will be part of the OSPF area. In this case, the
interface If3 must also be added as an OSPFInterface but the Passive property should be left at its
default value of enabled since this interface is connected to another router.

security gateway B, should then be set up in the same way.

Chapter 4: Routing

320

This manual is related to the following products: