Exporting the routes into an ospf as – Amer Networks E5Web GUI User Manual
Page 322

Web Interface
1.
Go to: Network > Routing > Routing Rules
2.
Click on the newly created ImportOSPFRoutes
3.
Go to: Routing Action > Add > DynamicRoutingRuleAddRoute
4.
Move the routing table main from Available to Selected
5.
Click OK
The same procedure should be repeated for security gateway B.
Example 4.13. Exporting the Routes into an OSPF AS
In this example, routes from the main routing table will be exported into an OSPF AS named
as_0. This must be done explicitly because routes are not exported automatically.
The exception to this are the routes for the OSPF interface networks which are exported
automatically (in this example If1_net and If3_net).
The steps are first performed for security gateway A.
First, add a new Dynamic Routing Policy Rule.
Command-Line Interface
Device:/> add DynamicRoutingRule
OSPFProcess=as_0
Name=ExportDefRoute
DestinationNetworkIn=all-nets
DestinationInterface=If3
From=RTable
RoutingTable=main
InControl
Follow the same steps used for the Web Interface below.
Web Interface
1.
Go to: Network > Routing > Routing Rules > Add > Dynamic Routing Policy Rule
2.
Specify a name for the rule. In this case, ExportAllNets
3.
Select the option From Routing Table
4.
Move the routing table main to the Selected list
5.
Choose all-nets in the ...Or is within filter for Destination Interface
6.
Click OK
Next, create an OSPF Action that will export the filtered route to the specified OSPF AS:
Chapter 4: Routing
322