beautypg.com

Using private ipv4 addresses – Amer Networks E5Web GUI User Manual

Page 430

background image

Service: H323

Source Interface: any

Destination Interface: lan

Source Network: 0.0.0.0/0 (all-nets)

Destination Network: lan_net

Comment: Allow incoming calls

3.

Click OK

Example 6.8. Using Private IPv4 Addresses

This scenario consists of two H.323 phones, each one connected behind the Clavister Security
Gateway on a network with private IPv4 addresses. In order to place calls on these phones over
the Internet, the following rules need to be added to the rule set in the security gateway. Make
sure there are no rules disallowing or allowing the same kind of ports/traffic before these rules.

As we are using private IPs on the phones, incoming traffic need to be SATed as in the example
below. The object ip-phone should be the internal IP of the H.323 phone behind each security
gateway.

InControl

Follow the same steps used for the Web Interface below.

Web Interface

Outgoing Rule:

1.

Go to: Policies > Add > IPRule

2.

Now enter:

Name: H323Out

Action: NAT

Service: H323

Source Interface: lan

Destination Interface: any

Source Network: lan_net

Destination Network: 0.0.0.0/0 (all-nets)

Comment: Allow outgoing calls

3.

Click OK

Incoming Rules:

Chapter 6: Security Mechanisms

430

This manual is related to the following products: