Amer Networks E5Web GUI - Manual (Page 630)

Change the properties of the Ethernet interface connected to the protected network so that
Transparent Mode is enabled.
C. Set any required L2TPv3 Server advanced options.
Some L2TPv3 clients may require the setting of the option Host Name or Router ID for the
server object. If the Host Name is set to None, the tunnel's Inner IP Address is used for this
setting.
The illustration below shows a typical setup for L2TPv3 where the protected network on
interface If3 can be accessed by L2TPv3 clients connecting to the L2TPv3 server listening on the
interface If2.
Figure 9.4. An L2TPv3 Example
Setting up the above scenario is covered in the example below.
Example 9.13. L2TPv3 Server Setup
Assume an L2TPv3 Server object called my_l2tpv3_if is to be set up so that L2TPv3 clients can
connect to it on the If2 interface. The aim is to have the protected network If3_net on the If3
interface accessible to these clients using L2TPv3.
Command-Line Interface
A. First, define the L2TPv3 Server object:
Device:/> add Interface L2TPv3Server my_l2tpv3_if
Chapter 9: VPN
630