Amer Networks E5Web GUI - Manual (Page 324)

• DebugDDesc - Log database description packets.
• DebugExchange - Log exchange packets.
• DebugLSA - Log LSA events.
• DebugSPF - Log SPF calculation events.
• DebugRoute - Log routing table manipulation events.
Each of these properties can be assigned one of the following values:
• Off - Nothing is logged.
• Low - Logs all actions.
• Medium - Logs all actions but with more detail.
• High - Logs everything with maximum detail.
Note: The high setting generates large amounts of data
When using the High setting, the security gateway will log a large amount of
information, even when just connected to a small AS. Changing the advanced setting
Log Send Per Sec Limit may be required.
Example 4.14. Enabling OSPF Debug Log Events
In this example, the DebugHello and DebugRoute log events will be enabled for the OSPFProcess
called my_ospf_proc.
Command-Line Interface
Device:/> set OSPFProcess my_ospf_proc DebugHello=Low DebugRoute=High
InControl
Follow the same steps used for the Web Interface below.
Web Interface
1. Go to: Network > Routing > OSPF > my_ospf_proc
2. Select the Debug option
3. Now enter:
• Hello Packets: Low
• Routing Table Manipulation: High
4. Click OK
Chapter 4: Routing
324