Comtech EF Data C5 - Manual (Page 82)

Specifications C5/K1/K3 Integrated Satellite Terminal System
2–48 Rev. 0
2.6.2 Remote Control
All terminal functions are controlled remotely through the remote connector on the rear
panel. Refer to Appendix B for the Remote Control Specification. Refer to Table 2-28 for
functions controlled.
Table 2-28. Remote Control Functions
Transmit
Digital Data Rate 2.4 kbit/s to 4.375 Mbit/s, in 1 bit steps
Code Rate BPSK 1/2
QPSK 1/2, 3/4, and 7/8
Encoder Type Viterbi
Sequential
Reed-Solomon Encoder On or Off
Transmit Frequency C-Band: 5.925 to 6.425 GHz, in 100 Hz steps
Ku-Band: 14.0 to 14.5 GHz, in 100 Hz steps
Transmit RF On or Off
Transmit Modulation Type EFD, CSC, FDC, and all closed networks
Transmit Power C-Band: +25 to +38 dBm, in 0.1 dB steps
Ku-Band K1: +17 to +30 dBm, in 0.1 dB steps
Ku-Band K3: +22 to +35 dBm, in 0.1 dB steps
Scrambler Enable On or Off
Differential Encoder On or Off
Transmit Spectrum Rotation Normal or Inverted
Transmit BPSK Bit Order Normal or Inverted
Carrier Only Mode Normal, Dual, Offset, or Center
Receive
Digital Data Rate 2.4 to 4375 kbit/s, in 1 bit steps
Code Rate BPSK 1/2
QPSK 1/2, 3/4, and 7/8
Decoder Type Viterbi or Sequential
Reed-Solomon Decoder On or Off
Receive Frequency C-Band:
3.7 to 4.2 GHz
Ku-Band:
10.95 to 11.45 GHz, in 100 Hz steps
11.2 to 11.7 GHz, in 100 Hz steps
11.7 to 12.2 GHz, in 100 Hz steps
12.25 to 12.75 GHz, in 100 Hz steps
Receive Modulation Type EFD, CSC, FDC, and all closed networks
Descrambler Enable On or Off
Differential Decoder On or Off
Receive Spectrum Rotation Normal or Inverted
Receive BPSK Bit Order Normal or Inverted
IF Loopback On or Off
Sweep Center -35 kHz to +35 kHz, in 1 Hz steps
Sweep Width 0 to 70 kHz, in 1 Hz steps
Sweep Reacquisition 0 to 999 seconds
BERT Threshold 10 -3 to 10 -8 or Off
Interface
Transmit OH Type ASYNC or None
Receive OH Type ASYNC or None
Transmit Driver Type V.35, EIA-422, or EIA-232