Comtech EF Data C5 - Manual (Page 313)

C5/K1/K3 Integrated Satellite Terminal System Remote Control Operation
Rev. 0 B–29
Bulk
Consol.
Status
(continued)
Parameter
Number
Parameter Name
(Command Reference)
Description
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
Demodulator IF frequency
(ref. 'DF_' command).
Demodulator rate
(ref. 'DR_' command).
Demodulator preset A assignment
(ref. 'ADRA_' command).
Demodulator preset B assignment
(ref. 'ADRB_' command).
Demodulator preset C assignment
(ref. 'ADRC_' command).
Demodulator preset D assignment
(ref. 'ADRD_' command).
Demodulator preset V assignment
(ref. 'ADRV_' command).
Descrambler enable
(ref. 'DE_' command).
Differential decoder enable
(ref. 'DDEC_' command).
Reserved null field.
Demodulator Band
(ref. 'DB_' command)
RF Loopback
(ref. 'RFL_' command).
IF Loopback
(ref. 'IFL_' command).
Sweep Center frequency
(ref. 'SCF_' command).
Sweep width range
(ref. 'SWR_' command).
Sweep reacquisition
(ref. 'SR_' command).
BER threshold
(ref. 'BERT_' command).
Demodulator type
(ref. 'DT_' command).
Demodulator decoder type
(ref. 'DDT_' command).
C-Band:
p15 = n.nnnnnnn, demodulator IF frequency in GHz.
Ku-Band:
p15 = nn.nnnnnnn, demodulator IF frequency in GHz.
p16 = nnnn_mmmm.mmm, code rate/data rate in Kbps.
p17 = nnnn_mmmm.mmm, code rate/data rate in Kbps.
p18 = nnnn_mmmm.mmm, code rate/data rate in Kbps.
p19 = nnnn_mmmm.mmm, code rate/data rate in Kbps.
p20 = nnnn_mmmm.mmm, code rate/data rate in Kbps.
p21 = nnnn_mmmm.mmm, code rate/data rate in Kbps.
p22 = n, where 'n' is '0' (off) or (on).
p23 = n, where 'n' is '0' (off) or (on).
Ku-Band:
p24 = n, where 'n' is 'A', 'B,' or 'C' (RX Frequency band).
p25 = n, where 'n' is '0' (off) or '1' (on).
p26 = n, where 'n' is '0' (off) or '1' (on).
p27 = snnnnn, sweep center frequency in Hertz.
p28 = nnnnn, sweep range in Hertz.
p29 = nnn, reacquisition time in seconds.
p30 = xxxx, BER threshold.
p31 = n, where 'n' is '0' (EFD), '1' (INTL), '3' (FDC), or '4'
(CSC).
p32 = n, where 'n' is '0' (SEQ) or '1' (VIT).