Comtech EF Data C5 - Manual (Page 297)

C5/K1/K3 Integrated Satellite Terminal System Remote Control Operation
Rev. 0 B–13
B.4 System
Time Of Day Command:
Response:
Status:
Response:
>add/TIME_hh:mmxx'cr''lf']
>add/TIME_hh:mmxx'cr''lf']
Where:
hh = 1 to 12 (hours).
mm = 00 to 59 (minutes).
xx = AM or PM.
Date Command:
Response:
Status:
Response:
>add/DATE_mm/dd/yyyy'cr''lf']
>add/DATE_mm/dd/yyyy'cr''lf']
Where:
mm = 1 to 12 (month).
dd = 1 to 31 (day).
yyyy = Year displayed in 4-digits (0000 to 9999).
Note: Year may be displayed in (yy) 2-digits (00 to 99).
Remote
Configures
the MODEM
for remote
operation. Command:
Response: >add/REM_'cr''lf'] The SDT5200 will respond to any status request at any time.
However, the SDT5200 must be in 'Remote Mode' to change
configuration parameters.
Clear Stored
Faults Command:
Response: >add/CLSF_'cr''lf'] This command is used to clear all stored faults logged by the
SDT5200.
Modem
Operation
Mode Command:
Response:
Status:
Response:
>add/MOM_xxxxxxx'cr''lf']
>add/MOM_xxxxxxx'cr''lf']
Where: xxxxxxx = TX_ONLY, RX_ONLY, or DUPLEX.
This command configures the modem for simplex or duplex
operation modes. When transmit only mode is selected receive
faults are inhibited and when receive only mode is selected
transmit faults are inhibited.
System
Modem Type Command:
Response:
Status:
Response:
>add/SMT_xxxxxx'cr''lf']
>add/SMT_xxxxxx'cr''lf']
Where: xxxxxx = ASYNC, EFD, or CUSTOM.
Save Modem
Configuration Command:
Response: >add/SMC_n'cr''lf'] Where: n = 1, 2, 3, 4, or 5 (stored configuration number).
This command saves the current modem configuration for
recall at a later time using the 'RMC_' command. Up to five
different modem configurations can be saved.
Recall
Modem
Configuration Command:
Response: >add/RMC_n'cr''lf'] Where: n = 1, 2, 3, 4, or 5 (stored configuration number).
This command causes the modem to be reprogrammed with
configuration parameters previously saved using the 'SMC_'
command. One of five saved configurations can be specified.
Local Modem
AUPC Mode Command:
Response:
Status:
Response:
>add/LMA_xxx'cr''lf']
>add/LMA_xxx'cr''lf']
Where: xxx = ON or OFF.
This command configures the modem for the LOCAL MODEM
AUPC mode. When 'ON' is selected, the AUPC configuration
can be entered.