Comtech EF Data C5 - Manual (Page 167)

C5/K1/K3 Integrated Satellite Terminal System Operation
Rev. 0 4–41
4.1.3.10 Remote AUPC
To view or change the Remote AUPC functions, enter the Remote AUPC menu from the
Function Select menu on the front panel. After entering the Remote AUPC menu, press
[
"] or [#] to select the Configuration or Monitor menu. Enter the selected menu by
pressing [ENTER]. Press [
"] or [#] to view the selected configuration parameters.
Note: This is only available with the ASYNC/AUPC overhead option.
4.1.3.10.1 Remote AUPC Configuration
Refer to Figure 4-13.
AUPC ENABLE Programs the AUPC feature on or off.
Upon entry, the status of the remote AUPC is displayed. Press
[
$] or [%] to make the selection. Press [ENTER] to execute the
change.
Note: This program is for control or last known status.
B-BAND LOOP BACK Programs the remote baseband loopback on or off.
Upon entry, the status of the remote baseband loopback is
displayed. Press [
$] or [%] to make the selection. Press [ENTER]
to execute the change.
Note: This program is for control or last known status.
TX 2047 PATTERN Programs the remote TX 2047 pattern on or off.
Upon entry, the status of the remote TX 2047 is displayed. Press
[
$] or [%] to make the selection. Press [ENTER] to execute the
change.
Note: This program is for control or last known status.
4.1.3.10.2 Remote AUPC Monitor
Refer to Figure 4-14.
2047 ERRORS Receive 2047 BER. This is a monitor point that displays the
current RX 2047 BER. If no data is available, “No Data” is
displayed.