Comtech EF Data C5 - Manual (Page 300)

Remote Control Operation C5/K1/K3 Integrated Satellite Terminal System
B–16 Rev. 0
AUPC Local
Carrier Loss
Action
(ASYNC
Overhead
only) Command:
Response:
Status:
Response:
>add/LCL_xxxx'cr''lf']
>add/LCL_xxxx'cr''lf']
Where: xxxx = HOLD, NOM, or MAX (power level setting
when local carrier loss).
AUPC
Remote
Carrier Loss
Action
(ASYNC
Overhead
only) Command:
Response:
Status:
Response:
>add/RCL_xxxx'cr''lf']
add/RCL_xxxx'cr''lf']
Where: xxxx = HOLD, NOM, or MAX (power level setting
when remote carrier loss).
Remote
Modem
AUPC
Commands Notes:
1. Always wait 3 seconds between consecutive remote
modem command/status polls.
2. If Local AUPC is not enabled status commands will
return last known condition. They will also request
status from the remote modem. This allows a second
request to return proper status.
Remote
AUPC
Enable
(ASYNC
Overhead
only) Command:
Response:
Status:
Response:
>add/RPC_xxx'cr''lf']
>add/RPC_xxx'cr''lf']
Where: xxx = ON or OFF (remote AUPC enable).
Remote
Interface
Substitution
Pattern
(Transmit
2047
Pattern) Command:
Response:
Status:
Response:
>add/RISP_xxx'cr''lf']
>add/RISP_xxx'cr''lf']
Where: xxx = ON or OFF (remote transmit 2047 pattern
enable).
Remote
Interface
Base Band
Loop Back
(ASYNC
Overhead
only) Command:
Response:
Status:
Response:
>add/RBBL_xxx'cr''lf']
>add/RBBL_xxx'cr''lf']
Where: xxx = ON or OFF (remote baseband loopback
enable).
Remote
Interface
Read Error
Status
(Received
2047
pattern) Command:
Response:
Command:
Response:
>add/RRES_nE-e'cr''lf']
Example:
>add/RRES_2E-6'cr''lf']
Where:
n = 1 to 9 (error rate number).
e = 2 to 6 (exponent).
This command returns 2047 BER from the remote AUPC
modem. If data is not valid, the message 'No_Data' is
returned in lieu of BER data.