Comtech EF Data C5 - Manual (Page 316)

Remote Control Operation C5/K1/K3 Integrated Satellite Terminal System
B–32 Rev. 0
Bulk
Consol.
Status
(continued)
Parameter
Number
Parameter Name
(Command Reference)
Description
(Note 1)
(Note 2)
(Note 1)
(Note 2)
(Note 1)
(Note 2)
71
72
73
74 to 81
82
83
84
85
86
87
88
89
90
Demodulator Spectrum Rotation
(ref. 'DSR_' command).
Reed-Solomon Encoder Enable
(ref. 'RSEN_' command).
Reed-Solomon Decoder Enable
(ref. 'RSDE_' command).
Reserved null fields.
(ref. 'BW_TX1' command).
TX Driver Type
(ref. 'TXDR_' command).
RX Driver Type
(ref. 'RXDR_' command).
Reserved null field.
ASYNC TX Overhead Baud Rate
(ref. 'TOBR_' command).
ASYNC RX Overhead Baud Rate
(ref. 'ROBR_' command).
ASYNC TX Channel Char. Length
(ref. 'TCCL_' command).
ASYNC RX Channel Char. Length
(ref. 'RCCL_' command).
ASYNC TX Channel Stop Bits
(ref. 'TCSB_' command).
ASYNC RX Channel Stop Bits
(ref. 'RCSB_' command).
p71 = n, where 'n' is '0' (NRM) or '1' (INV).
p72 = n, where 'n' is '0' (off) or '1' (on).
p73 = n, where 'n' is '0' (FF), '1' (ON), or '2' (CORR_OFF).
p82 = n, where 'n' is '0' (G.703), '1' (V.35), '2' (RS422), or
'3' (RS232).
p83 = n, where 'n' is '0' (G.703), '1' (V.35), '2' (RS422), or
'3' (RS232).
p85 = nnnnn, where 'nnnnn' is the currently programmed
baud rate.
p86 = nnnnn, where 'nnnnn' is the currently programmed
baud rate.
p87 = n, where 'n' is the currently programmed character
length.
p88 = n, where 'n' is the currently programmed character
length.
p89 = n, where 'n' is the current number of stop bits
programmed.
p90 = n, where 'n' is the current number of stop bits
programmed.