Comtech EF Data C5 - Manual (Page 182)

Operation C5/K1/K3 Integrated Satellite Terminal System
4–56 Rev. 0
4.1.3.11.4 Utility System
Refer to Figure 4-18.
TIME: HH:MM:SS AM/PM
DATE: MM/DD/YY Time of day and date display/set function.
The current time and date in the modem’s memory are displayed
when selected. To change the modem time and/or date, press
[ENTER]. Press [
"] or [#] to position the cursor over the parameter
to be changed. Press [
$] or [%] to change the parameter. Once the
parameters are displayed as desired, press [ENTER] to set the time
and date.
REMOTE BAUD RATE
X PARITY
The parity and baud rate settings of the modem are displayed.
To change the modem baud rate and/or parity, press [ENTER]. Press
[
"] or [#] to position the cursor over the parameter to be changed.
Press [
$] or [%] to change the parameter. Once the parameters are
displayed as desired, press [ENTER] to set the baud rate and parity.
The parity can be set to EVEN, ODD, or NONE.
REMOTE ADDRESS The current modem address is displayed (1 to 255).
Note: Address 0 is reserved as a global address.
To change the remote address, press [ENTER]. Press [
$] or [%] to
make the selection. Press [ENTER] to execute the change.
REMOTE TYPE Select EIA-485 (2-WIRE), EIA-485 (4-WIRE), or EIA-232.
Upon entry, the operational status may be changed. Press [
$] or [%] to
make the selection. Press [ENTER] to execute the change.
OPERATION MODE Programs the modem for DUPLEX, TRANSMIT ONLY, or
RECEIVE ONLY operation.
Upon entry, the operational status may be changed. Press [
$] or [%] to
make the selection. Press [ENTER] to execute the change.
Note: When TRANSMIT ONLY or RECEIVE ONLY are selected,
the appropriate faults are masked from the Faults and Stored Faults
menus.
YEAR DISPLAY Selects either 2-digit or 4-digit display.
Upon entry, the operational status may be changed. Press [
$] or [%] to
make the selection. Press [ENTER] to execute the change.