Comtech EF Data C5 - Manual (Page 290)

Remote Control Operation C5/K1/K3 Integrated Satellite Terminal System
B–6 Rev. 0
Set
Modulator
Output
Power Level Command:
Response:
Status:
>add/MOP_snn'cr''lf']
>add/MOP_snn.n'cr''lf']
C-Band:
Where: snn.n = +25 to +38 in 1 steps.
K1 Ku-Band:
Where: snn.n = +17 to +30 in 1 steps.
K3 Ku-Band:
Where: snn.n = +22.0 to +35.0 in 0.1 steps (nominal
range in dBm).
Note: The MOP_ command will return status only when
local AUPC is enabled.
Scrambler
Enable Command:
Response:
Status:
Response:
>add/SE_xxx'cr''lf']
>add/SE_xxx'cr''lf']
Where: xxx = ON or OFF.
Differential
Encoder
Enable Command:
Response:
Status:
Response:
>add/DENC_xxx'cr''lf']
>add/DENC_xxx'cr''lf']
Where: xxx = ON or OFF.
Modulator
Type Command:
Response:
Status:
Response:
>add/MT_xxxx'cr''lf']
>add/MT_xxxx'cr''lf']
Where: xxxx = EFD (EF DATA CLOSED NETWORK),
CSC (COMSTREAM CLOSED NETWORK), FDC
(FAIRCHILD CLOSED NETWORK).
Modulator
Encoder
Type Command:
Response:
Status:
Response:
>add/MET_xxx'cr''lf']
>add/MET_xxx'cr''lf']
Where: xxx = VIT (K-7 VITERBI ENCODER), SEQ
(SEQUENTIAL ENCODER).
Modulator
Spectrum
Rotation Command:
Response:
Status:
Response:
>add/MSR_xxx'cr''lf']
>add/MSR_xxx'cr''lf']
Where: xxx = NRM (normal spectrum), INV (inverted
spectrum).
Reed-
Solomon
Encoder
Enable Command:
Response:
Status:
Response:
>add/RSEN_xxx'cr'lf']
>add/RSEN_xxx'cr''lf']
Where: xxx = ON or OFF.
Transmit
BPSK Data
Ordering Command:
Response:
Status:
Response:
>add/TDA_xxx'cr''lf']
>add/TDA_xxx'cr''lf']
Where: xxx = NRM (STANDARD), INV (NON-
STANDARD).
Carrier Only
Mode Command:
Response:
Status:
Response:
>add/COM_xxxxxx'cr''lf']
>add/COM_xxxxxx'cr''lf']
Where: xxxxxx = OFF (NORMAL-MODULATED), DUAL
(DUAL-CW), OFFSET (OFFSET-CW), CENTER
(CENTER-CW).