Comtech EF Data C5 - Manual (Page 292)

Remote Control Operation C5/K1/K3 Integrated Satellite Terminal System
B–8 Rev. 0
IF Loopback Command:
Response:
Status:
Response:
>add/IFL_xxx'cr''lf']
>add/IFL_xxx'cr''lf']
Where: xxx = ON or OFF.
Sweep Center
Frequency Command:
Response:
Status:
Response:
>add/SCF_snnnnn'cr''lf']
>add/SCF_snnnnn'cr''lf']
Where: snnnnn = -35000 to +35000 in 1 Hz steps.
Sweep Width
Range Command:
Response:
Status:
Response:
>add/SWR_nnnnnn'cr''lf']
>add/SWR_nnnnnn'cr''lf']
Where: nnnnnn = 0 to 70000 in 1 Hz steps.
Sweep
Reacquisition Command:
Response:
Status:
Response:
>add/SR_xxx'cr''lf']
>add/SR_xxx'cr''lf']
Where: xxx = 0 to 999 (number of seconds).
Bit Error Rate
Threshold Command:
Response:
Status:
Response:
>add/BERT_xxxx'cr''lf']
>add/BERT_xxxx'cr''lf']
Where: xxxx = NONE, or 1E-n, where n = 3, 4, 5, 6, 7, or
8 (exponent of threshold).
Demodulator
Type Command:
Response:
Status:
Response:
>add/DT_xxxx'cr''lf']
>add/DT_xxxx'cr''lf']
Where: xxxx = EFD (EF DATA CLOSED NETWORK),
CSC (COMSTREAM CLOSED NETWORK), FDC
(FAIRCHILD CLOSED NETWORK).
Demodulator
Decoder Type Command:
Response:
Status:
Response:
>add/DDT_xxx'cr''lf']
>add/DDT_xxx'cr''lf']
Where: xxx = VIT (K-7 VITERBI ENCODER), SEQ
(SEQUENTIAL ENCODER).
Demodulator
Spectrum
Rotation Command:
Response:
Status:
Response:
>add/DSR_xxx'cr''lf']
>add/DSR_xxx'cr''lf']
Where: xxx = NRM (normal spectrum), INV (inverted
spectrum).
Reed-
Solomon
Decoder
Enable Command:
Response:
Status:
Response:
>add/RSDE_xxx'cr''lf']
>add/RSDE_xxx'cr''lf']
Where: xxx = ON, OFF, or CORR_OFF.
Receive BPSK
Data Ordering Command:
Response:
Status:
Response:
>add/RDA_xxx'cr''lf']
>add/RDA_xxx'cr''lf']
Where: xxx = NRM (STANDARD), INV (NON-
STANDARD).