Comtech EF Data C5 - Manual (Page 322)

Remote Control Operation C5/K1/K3 Integrated Satellite Terminal System
B–38 Rev. 0
Change
Status Command:
Response: >add/CS_x'cr''lf'] This command indicates that a change has or has not
occurred on either the BCS_ or the BCSF_ response
since the last BCS_ or BCSF_ poll.
The 'x' character is defined as follows:
'@' = no change since last BCS_ and BCSF_ polls.
'A' = BCS_ response has changed since last BCS_
poll.
'B' = BCSF_ response has changed since last BCSF_
poll.
'C' = Both responses have changed since last BCS_
and BCSF_ polls.
Equipment
Type Command:
Response: >add/ET_tttttttt_xxx.yyy.zzz'cr''lf'] Where:
tttttttt = Equipment type.
xxx.yyy.zzz = Software version.
This command returns the equipment type and the
software version of the addressed device.
Monitor &
Control
Firmware
Information Command:
Response: >add/MCFI_'cr'
VER_xxx.yyy.zzz'cr'
FW/nnnnnn-ddr'cr'
mm/dd/yy'cr''lf'] Where:
xxx.yyy.zzz = Software version number (0.0.0 to
999.999.999).
nnnnnn = Firmware number (0 to 999999).
dd = Firmware dash number (0 to 99).
r = Firmware revision (-, or A to Z).
DATA ROM
Firmware
Information Command:
Response: >add/DFI_'cr'
FW/nnnnnn-ddr'cr'
mm/dd/yy'cr''lf'] Where:
nnnnnn = Firmware number (0 to 999999).
dd = Firmware dash number (0 to 99).
r = Firmware revision (-, or A to Z).
Note: If Dash number is not used, '-dd' will be reported.
Boot M&C
Firmware
Information Command:
Response: >add/BFI_'cr'
VER_xxx.yyy.zzz'cr'
FW/nnnnnn-ddrr'cr'
mm/dd/yy'cr''lf'] Where:
xxx.yyy.zzz = Software version number (0.0.0 to
999.999.999).
nnnnnn = Firmware number (0 to 999999).
dd = Firmware dash number (0 to 99).
rr = Firmware revision (-, or A to Z).