Comtech EF Data C5 - Manual (Page 324)

Remote Control Operation C5/K1/K3 Integrated Satellite Terminal System
B–40 Rev. 0
Built In Self
Test Command:
Response:
Response:
Status:
Response:
for (OFF):
>add/BIST_xxx'cr''lf']
for (RUN):
>add/BIST_xxx'cr'
ST_xxx'cr''lf']
>add/BIST_xxx'cr''lf']
Where: xxx = OFF (self test disabled), RUN (run self test
now).
Self Test (OK/FLT)
Note: Allow 35 Seconds for response to RUN the Self
Test.
LCP Data
Bits
Command Command:
Response: >add/DAT8_z'cr''lf'] Where:
Dddd = duct Device Number: ASCII hexadecimal
values representing the device number to erase.
These values should be copied directly from the
field from the initialization file. This is ignored for
multiple paged memory schemes, but needed for
single paged schemes.
Z= Status: One byte binary value (0x00 - 0xFF)
pertaining to the execution of the previous command.
Valid status values returned: LCP_FAILURE,
LCP_SUCCESS.
Each letter represents 1 byte.
State Of
Product Command:
Response: >add/SOP_'cr'
add'cr'
abc'cr'
rrrrr bps'cr'
'cr'
'cr''lf']
Product Address
Data format
Baud Rate
Comm Type
abc = Explained below.
a = Number of data bits ( 7 )
b = Parity type (O, E, N)
c = Number of stop bits (1)
rrrr = baud rate ('150', '300', '600', ' 200', '2400', '4800',
'9600', '14.4K', '19.2K').
= Variable length strings explaining
communication hardware type 'RS-485, 2 wire', 'RS-485,
4 wire' 'RS-232'.
= Variable length strings explaining the
intention of the product. 'Under normal system operation',
'REFLASH of BULK firmware required', 'REFLASH of
M&C firmware required'.