Rockwell Automation 57C650 AutoMax Programming Executive Version 3.8 - Manual (Page 274)

NĆ6 AutoMax Programming Executive Version 3.x
Rack Token
If a rack is selected:
The token status line will display information about the rack token for the selected
rack.
If the rack token does not exist, the commands MAKE HELD, MAKE NOT HELD,
and CLEAR PASSWORD will be disabled.
If the rack token does exist and is held, the commands CREATE and MAKE HELD
will be disabled. If the token password has not been set, CLEAR PASSWORD will
also be disabled.
If the rack token exists but is not held, the commands CREATE, MAKE NOT
HELD, and CLEAR PASSWORD will be disabled and the information about
whether the password is set will not be displayed.
If no rack is selected, all the commands except EXIT will be disabled and the
token status information will not be displayed.
System Token
If a system is selected:
The token status line will display information about the system token for the
selected system.
If the system token does not exist, the commands MAKE HELD, MAKE NOT
HELD, and CLEAR PASSWORD will be disabled. Information about whether the
token is held and whether the password is set will not be displayed.
If the system token does exist and is held, the commands CREATE and MAKE
HELD will be disabled. If the token password has not been set, CLEAR
PASSWORD will also be disabled.
If the system token exists but is not held, the commands CREATE, MAKE NOT
HELD, and CLEAR PASSWORD will be disabled and information about whether
the password is set will not be displayed.
If no system is selected, all the commands except EXIT will be disabled and the
token status information will not be displayed.
All Tokens in System
If a system is selected:
The token status information will not be displayed.
If the system token does not exist, the commands MAKE HELD, MAKE NOT
HELD, and CLEAR PASSWORD will be disabled.
If the system token does exist and is held, the command CREATE will be
disabled.
If the system token exists but is not held, the command CREATE will be disabled.
If one of the commands MAKE HELD, MAKE NOT HELD, or CLEAR PASSWORD
is selected, and not all the rack tokens for the system exist, a message will be
displayed for each nonĆexisting
rack token, asking whether the user would like to create it. Processing will
continue following each response.
If no system is selected, all the commands except EXIT will be disabled and the
token status information will not be displayed.