Rockwell Automation 57C650 AutoMax Programming Executive Version 3.8 - Manual (Page 216)

18Ć28 AutoMax Programming Executive Version 3.x
18.4.12 Searching for a Variable Name
You can search a task for a variable by following the directions below.
1. Enter F2 to initiate the search.
2. Enter the name of the variable.
3. By entering one of the letters indicated below, you can qualify the
search to examine only certain types of elements for the variable:
A Ć All contacts and coil
O Ć Normally open contacts
C Ć Normally closed contacts
U Ć Upward transition contacts
D Ć Downward transition contacts
The task will be scanned from the beginning for a match. If a
match is found, the search stops and the ladder sequence
containing the match is displayed.
4. If you want to search for another instance of the same variable,
enter Alt/F2. This function will cause the search to continue from
the sequence at which it had stopped until the next match. A
search must have been initiated with the F2 function key in order
to use this function. It may be reĆexecuted as many times as
necessary.
18.4.13 Inserting a New First Sequence
To insert a sequence before the existing first sequence, follow the
directions below. This is the sole method of inserting a sequence
before an existing first sequence. F10 can also be used to insert at
any place in the task if the sequence number entered is not already
in the task.
1. Enter F10.
2. Enter a sequence number smaller than the current first sequence
number.
3. Proceed with the insert operation described in 18.4.2 and 18.4.3
above.
18.4.14 Remark Sequence Text
You can use Alt/F1 to toggle on/off the display of Remark sequence
text.