Rockwell Automation 57C650 AutoMax Programming Executive Version 3.8 - Manual (Page 271)

NĆ3 Tokens and Locking
Changing Token Passwords
The Set Token Password command on the System and Rack menus can be
used to change the token password for the system or a selected rack. When the
command is executed, the following dialog box will be displayed:
The following fields must be entered:
User Name:
A user name of up to 30 characters. The default is
the name entered in the AutoMax Setup.
Old Password: The old password. Each character will be echoed as an
asterisk (*). This information is required to verify that the user is
authorized to change the password. If the old password was
, this field will not appear and any user may change the
password.
New Password: A password of up to 15 characters. Each character will be
echoed as an asterisk (*).
Verification: The new password again. Each character will be echoed as an
asterisk (*). This field is required to make sure the user typed
the new password correctly. If this entry does not match the
new password, the screen will display an error message and
the cursor will be returned to the New Password field.