Rockwell Automation 825-P Modular Protection System for Motors User Manual - Manual (Page 95)

Rockwell Automation Publication 825-UM004D-EN-P - November 2012 95
Configuring Protection & Logic Functions Chapter 6
I/O Assignments
Trip Relay I/O
Table 42 - Trip Relay Assignments
Setting Prompt 0 1 2 3 4 5 6 7 Description
TRIP A X Overload
X Undercurrent
X Jam
X Current Imbalance
X Short Circuit
X RTD (Winding/Bearing)
X PTC
X Ground Fault (Residual)
TRIP B X VAR
X Underpower
X Undervoltage
X Overvoltage
X Phase Reversal
X Power Factor
X Speed Switch
X Ground Fault (Core Balance)
TRIP C X Start Time
X Frequency 1
X Frequency 2
X RTD (Other)
X RTD (Ambient)
X PTC Error
X RTD Error
X MCM Error
TRIP D X Comm Idle
X Comm Loss
X Remote Trip
X Comm Fault
X Reserved
X Reserved
X Reserved
X Reserved
NOTE: The 825-P uses settings TRIPA through TRIPD and setting TRIP FAIL-SAFE (see Table 38)
to determine the operation of the Trip Output.