Rockwell Automation 825-P Modular Protection System for Motors User Manual - Manual (Page 36)

36 Rockwell Automation Publication 825-UM004D-EN-P - November 2012
Chapter 3 Front Panel Operation
The Test/Reset push button has two functions if it has not been disabled.
Pressing the Test/Reset push button resets the Trip LED and the Trip output
of the relay. If a trip condition is active, the front-panel message displays the
following:
Reset Failed
TRIP is active
To test the trip output, press the Test/Reset push button for longer than two
seconds.
The Test/Reset push button is disabled when Disable settings are active (see
Table 44).
Table 4 - Front Panel Push Button Functions
Push Button Function
UpArrow Move up within a menu or data list.
While editing a setting value, increase the value of the underlined
digit.
DownArrow Move down within a menu or data list. While editing a setting value,
decrease the value of the underlined digit.
LeftArrow Move the cursor to the left.
While viewing event data, move to data for a newer event.
RightArrow Move the cursor to the right.
While viewing Event data, move to the data for an older event.
Esc Re-activate the front panel display back-lighting.
Back out from the current menu or display.
Enter Move from the default display to the main menu.
Select the menu item at the cursor.
Select the displayed setting to edit the setting.
Trip/Reset The Test/Reset push button has two functions if it has not been
disabled.
Pressing the Test/Reset push button resets the Trip LED and the Trip
output of the relay. If a trip condition is active, the front-panel
message displays the following:
Reset Failed
TRIP is active
To test the trip output, press the Test/Reset push button for longer
than two seconds.
The Test/Reset push button is disabled when Disable settings are
active
ESC
TEST/RESET