Rockwell Automation 825-P Modular Protection System for Motors User Manual - Manual (Page 3)

Rockwell Automation Publication 825-UM004D-EN-P - November 2012 3
European Communities (EC)
Directive Compliance
If this product has the CE mark it is approved for installation within the European Union and European Economic Area
(EEA). It has been designed and tested to meet the following directives.
EMC Directives
This product is tested to meet the Council Directive 89/336/EEC Electromagnetic Compatibility (EMC) by applying the
following standards, in whole:
• EN 60947-4-1 — Low-Voltage Switchgear and Controlgear: Part 4: Contactors and Motor Starters - Section 1:
Electromechanical Contactors and Motor Starters
• EN 60947-5-1 — Low-Voltage Switchgear and Controlgear: Part 5: Control Circuit Devices and Switching Elements -
Section 1: Electromechanical Control Circuit Devices
This product is intended for use in an industrial environment.
Low Voltage Directive
This product is tested to meet Council Directive 73/23/EEC Low Voltage as amended by 93/68/EEC by applying the
safety requirements of EN 60947-4-1 and EN 60947-5-1. For specific information required by EN 60947-4-1 and EN
60947-5-1, see the appropriate sections in this publication.
Notice
This product has been designed for environment A. Use of this product in environment B can cause unwanted
elctromagnetic disturbances in which case the user could be required to take adequate mitigation measures.