Select ok, Correct the fault input to the aux out 5, Do one of the following – Rockwell Automation 825-P Modular Protection System for Motors User Manual User Manual

Page 128: When the download is successful, select ok

128

Rockwell Automation Publication 825-UM004D-EN-P - November 2012

Chapter 9 825-PDN DeviceNet Communication Card

28.

Select OK.

29.

Moving cursor into the grid, place Aux Out 5 to the right of the AND
function block

30.

Correct the Fault Input to the Aux Out 5.

31.

Do one of the following:
•

In the toolbar, select Tools.

•

From the pull-down menu, select Logic Verify.

32.

To toggle out of edit mode if you are online with a device, select Tools.

33.

After selecting Edit from the main menu, select Download from the pull-
down menu (right corner of the toolbar).

34.

When the download is successful, select OK.

35.

From the same pull-down menu, select Logic Enable On.

36.

The 825-P Modular Protection System is now programmed and the logic
is active.

NOTE:

The PLC key switch must be in the Program position. If not, the download does not occur and
a generated error occurs.