Lull 944E-42 Service Manual - Manual (Page 806)

Transfer Carriage
11.4 Model 644E-42/944E-42 Rev. 6/04
11.3.1 Transfer Carriage Removal
1. Level the vehicle, place the travel select lever in the
(N) NEUTRAL DETENT position, engage the
parking brake.
2. Move the transfer carriage 5' 8'' (172 cm) so that the
pin (1) connecting the transfer cylinder to the
transfer carriage is at a pin access hole (2) near the
rear of the cab.
3. Remove the top snap ring (3) from the transfer
carriage pin (1).
4. Temporarily tape the pin in place so it will not fall out
during the following procedure.
5. Move the transfer carriage all the way forward.
6. Remove the tape and the pin (1).
7. If you are replacing the pin, remove the bottom snap
ring (3).
8. Shut the engine OFF.
9. Place an Accident Prevention Tag on both the
ignition switch and steering wheel, stating that the
vehicle should not be operated. (Refer to Section
1.5, “Accident Prevention Tag Usage.”)
10. Open the engine compartment cover. Allow the
engine, transmission and hydraulic fluid to cool.
11. If the vehicle has dual batteries, disconnect both
negative battery cables (4 and 5) from both
batteries.
To access the lower battery (6), loosen the knob (7)
far enough so that the lip (8) on the upper battery box
clears the knob. Lift up the upper battery box (9) and
swing it out, so that the box clears the hydraulic tank
support bracket, to gain access to the lower negative
battery cable (4). Disconnect the lower negative
battery cable.
MU3050
1
2
MU5490
3
1
MU0650
4
5
6
7
8
9