Lull 944E-42 Service Manual - Manual (Page 720)

Electrical System
9.210 Model 644E-42/944E-42 Rev. 6/04
a. Ignition Switch Removal
1. Unlock and open the engine cover (1).
2. If the vehicle has dual batteries, disconnect both
negative battery cables (3 and 4) from both
batteries.
To access the lower battery (5), loosen the knob (6)
far enough so that the lip (7) on the upper battery box
clears the knob. Lift up the upper battery box (8) and
swing it out, so that the box clears the hydraulic tank
support bracket, to gain access to the lower negative
battery cable (3). Disconnect the lower negative
battery cable.
3. Remove the four button head screws (9) securing
the lower dash cover (10) to the front dash. Remove
the lower dash cover.
4. Remove the knurled nut (11) securing the ignition
switch (12) to the dash.
5. Reach up and under the dash to work the ignition
switch and wiring out from behind the dash
panel (17).
6. Label and disconnect the wires (13, 14 and 15)
connected to the ignition switch (12). Remove the
nuts (16) securing the wires to the terminals on the
back of the switch. Save the hardware for later re-
assembly. Remove the switch from the vehicle.
4110390
1.
2.
OU0780
1
2
2
MU0650
3
4
5
6
7
8
MU3350
9
10
MU3530
11
12 13
14
15
16
17
18