Lull 944E-42 Service Manual - Manual (Page 184)

Transmission: ZF 4WG-92/98 TSC & Transfer Case: ZF TB92-I4
6.8 Model 644E-42/944E-42 Rev. 6/04
10. Remove the four capscrews (1) securing the inlet
flange halves (2) to the pump (3). Remove the inlet
tube (4) and o-ring (5).
11. Remove the four capscrews (6) securing the front
outlet flange halves (7) to the pump (3). Remove the
front outlet hose (8) and o-ring (9). Cap the outlet
hose to prevent unnecessary fluid spillage.
12. Remove the four capscrews (10) securing the rear
outlet flange halves (11) to the pump (3). Remove
the rear outlet hose (12) and o-ring (13). Cap the
outlet hose to prevent unnecessary fluid spillage.
13. Remove the four plain flat washers (14) and
capscrews (15) securing the pump (16) to the
transmission. Remove the pump and o-ring (17)
from the transmission.
14. Connect a lifting strap or chain to the lifting ring (18)
at the top of transmission, and to a suitable hoist or
overhead crane. Operate the hoist or crane to
remove any slack prior to lifting, but DO NOT raise
the transmission at this time. Connect another
suitable lifting device to the lifting loop on the
flywheel end of the engine. Remove the slack, but do
not lift on the engine.
15. Remove the twelve hex bolts (19) securing the
torque converter housing to the rear of the engine.
MU1890 MU1890
1 2
3
4
5
6
7
8
9
10
11
12
13
MU1990
14
15
16
17
MU0962
Front
18
19