Lull 944E-42 Service Manual - Manual (Page 244)

Engine: Cummins 4BT 3.9, B4.5T and QSB 4.5T
7.42 Model 644E-42/944E-42 Rev. 6/04
9. Connect the shift solenoid wiring harness
connectors (1, 2, 3, 4, 5, and 6). Connect the
transmission temperature switch lead (7). Attach any
clips used for securing the wiring harness to the
transmission, and secure the harness.
10. Connect the fuel shut off solenoid (644E-42, SN
20118 & Before, 0160002519 thru 0160003689 and
944E-42), fuel shut off valve (644E-42, SN
0160003690 & After) wire harness lead (8).
11. Connect the engine coolant temperature switch
lead (9) and the oil pressure switch lead (10).
12. Attach any clips securing the power harness and
sensor harness to the engine. Secure the power
harness and sensor harness.
13. Secure the negative (-) battery cable (11) to the
starter ground stud (12). Torque mounting hardware
to 40-45 lb-ft (54-61 Nm).
14. Connect the positive (+) battery cable (13) and
starter positive buss bar (14), with the wires (15) still
connected, at the positive starter stud (16). Torque
mounting hardware to 40-45 lb-ft (54-61 Nm).
15. Connect the frame ground cable (17) and negative
buss bar, with the wires still connected (18), at the
engine block (19). Torque mounting hardware to
69-78 lb-ft (94-106 Nm).
16. Insert the fork terminal of the blue wire (20) into the
protective cover (21) on the starter solenoid
terminal. Use a small phillips screwdriver to tighten
the screw (22) securely.
17. Snap the tethered cap back in place over the screw
in the protective cover.
TR6A
TRG4
TR4A
TRG2
TR5A
TRG1
TR3A
TRG3
TR1A
TRG5
TR2B
TRG6
MU3080
1
2
3
4
5
6
7
MU3090
8
9
10
MU6570
16
13
14
15
12
11
19
18
17
20
22
21
MU6580