Lull 944E-42 Service Manual - Manual (Page 108)

Cab and Covers
4.4 Model 644E-42/944E-42 Rev. 6/04
4.3 OPEN CAB COMPONENTS
4.3.1 Seat and Seat Belt
a. Seat Removal
Note: Two types of seating are available on this vehicle,
a standard seat (1) and a seat with adjustable
suspension (4). Both seats can be removed and
installed using the same procedure. The seat belts (2)
for the standard seat are bolted directly to the seat riser
(3) whereas on the suspension seat (4), the seat belts
(5) are bolted to a bracket, which is attached to the seat
back. On the suspension seat, the seat belts have
additional support through the use of tethers (6). The
tethers are attached, at one end, to the seat belt
mounting hardware on the seat, and at the other end,
are bolted to the seat riser.
1. Park the vehicle on a firm, level surface. Level the
vehicle, ground the attachment, place the travel
select lever in the (N) NEUTRAL DETENT position,
engage the parking brake switch and shut the
engine OFF.
2. Remove the two capscrews (7), flat washers (8) and
spacers (9) securing the tethers (6) to the seat
riser (10).
3. Remove the elastic locknuts (11) and flat
washers (12) securing the seat (4) to the seat
riser (10). Carefully remove the seat (4) from the
cab.
4. If the seat is to be replaced: Remove the two
capscrews (13), washers (14), seat belt
assembly (5), spacers (15) and flanged nuts (16).
Transfer these parts and two tethers (6) to the
replacement seat with the seat out of the cab.
MU4660
1
2
3
MU1850
~
4
5
6
7
8
9
10
11
12
6
13
14
15
13
14
15
16
17
16
5