Lull 944E-42 Service Manual - Manual (Page 168)

Axles, Drive Shafts, Wheels, Tires and Brakes
5.22 Model 644E-42/944E-42 Rev. 6/04
5.5.4 Installing Wheel and Tire Assembly
Onto Vehicle
IMPORTANT: The tires must be installed onto the
wheels to rotate in the proper direction. The wheel and
tire assemblies must be installed with the directional
tread pattern “arrows” rotating in the direction of forward
travel.
1. Position wheel onto studs on wheel end of axle.
2. Install wheel lug nuts. Be sure to install the lock
washers (1 and 3), with narrow side toward the rim,
under the lug nuts (2 and 4).
3. (644E Only) Use the torque sequence diagram
(A - H), to alternately check the torque of each of the
eight lug nuts. Torque 430 - 470 lb-ft (583 - 637 Nm).
(944E Only) Use the torque sequence diagram
(A - K), to alternately check the torque of each of the
ten lug nuts. Torque 430-470 lb-ft (583-637 Nm).
4. Inflate the tire to 65 psi (448 kPa).
5. Drive the vehicle and aggressively steer and brake
several times. Re-torque the lug nuts.
PT07202
Tread “arrows” must
point in the direction of
forward travel.
Install tires onto wheels to
rotate in proper direction
and with air valve facing
toward outside of vehicle.
A
B
C
E G
H F
D
OU0140
1
2
A
B
C
E
G
J
K
H
F
D
MU5200
3
4