Lull 944E-42 Service Manual User Manual
Page 694
Electrical System
9.184
Model 644E-42/944E-42
Rev. 6/04
7. Rotate the suspect bulb holder assembly
(1 through 14) 1/4 turn counterclockwise.
8. Remove and replace bulb. All bulbs should be
replaced with a comparable OS 12V/1.2W bulb
except the alternator indicator (8). That bulb should
be replaced with a comparable OS 12V/3W bulb.
9. Place bulb holder assembly back into appropriate
space and rotate 1/4 turn clockwise.
10. Replace the dash panel rear access plate (15).
Secure with four phillips screws, (16).
11. Place the front dash panel (17) into the cut-out in the
cover (18), and secure in place using the two
nuts (19) and retaining brackets (20).
12. Connect the wire harness connector (21) at the rear
of the front dash panel (17).
13. Install the front dash panel cover (18), with the front
dash panel (17), to the dash in the cab. Secure in
place using five capscrews (22) and flat
washers (23). Torque to 25 - 36 lb-ft (3,5 - 5 Nm).
Item
Description
1
Hydraulic Oil Filter Restriction
2
Low Brake Pressure
3
Engine Air Filter Restriction
4
Hydraulic Oil Temperature
5
Instrument Gauge Backlights
6
Transmission Temperature
7
Park Brake
8
Alternator
9
Engine Oil Pressure
10
Engine Air-Intake Heater
11
Stabil-TRAK™ Slow Pivot Mode
12
High Beam (Optional)
13
Stabil-TRAK™ Locked Mode
14
Turn Signal (Optional)
MU3460
MU3470
16
15
MU3440
22
23
18
17
21
19
20