Lull 944E-42 Service Manual - Manual (Page 175)

5.29 Model 644E-42/944E-42 Rev. 6/04
Axles, Drive Shafts, Wheels, Tires and Brakes
Note: If the brake discs are worn beyond .0.167"
(4,25 mm), the brake disc must be replaced on both
sides of the axle at the same time.
7. Repeat steps 5 and 6 for the other side of the axle.
8. Fill the axle with Universal Tractor Fluid through the
axle fill hole (8) until the oil level is even with both
axle level holes (9).
See chart of approved fluids. The axle capacity is
9.5 qt (9 liters) for the rear axle. Fill axle slowly, the
oil has to run across the differential. Allow time for the
oil to run across the differential. Axle level is correct
when oil is up to both level plugs.
9. Reassemble the level plugs using new o-rings.
10. Re-install the axle fill plug (8) into axle housing.
11. Remove the remote portable hydraulic pressurizing
unit on the parking brake gauge port (3).
12. Place the valve plate cover (2) back inside the cab.
Reinstall the capscrews (1). Torque capscrews to, 18
lb-ft (25 Nm).
MU0580
8
9
Approved Universal Tractor Fluid
John Deere JDM J20C (HY-GARD)
Ford/New Holland ESN-M2C134-D
(HYDRAULIC OIL 134)
Massey-Ferguson M-1141 (PERMANTRAN III)
Chevron CHEVRON 1000 THF