Lull 944E-42 Service Manual - Manual (Page 675)

9.165 Model 644E-42/944E-42 Rev. 6/04
Electrical System
c. Starter Removal
1. Unlock and open the engine cover (4).
2. If the vehicle has dual batteries, disconnect both
negative battery cables (6 and 7) from both
batteries.
To access the lower battery (8), loosen the knob (9)
far enough so that the lip (10) on the upper battery
box clears the knob. Lift up the upper battery box (11)
and swing it out, so that the box clears the hydraulic
tank support bracket, to gain access to the lower
negative battery cable (8). Disconnect the lower
negative battery cable.
3. At the negative starter stud (12), label and
disconnect the negative (-) battery cable (13).
4. At the positive starter stud (14), label and disconnect
the positive (+) battery cable (15) and starter positive
buss bar (16). Leave the wires (18) connected to the
starter positive buss bar.
5. For jump start protection, a protective plastic
cover (17) is installed around the starter solenoid
terminal and mounting screw. A removable, tethered
cap (19) allows access to the terminal mounting
screw.
6. Use a small, flat knife blade (20) inserted next to the
cap (19) so that the cap pops out of the protective
cover.
7. Label the blue wire (21) from the starter solenoid
terminal. Use a small phillips screwdriver to loosen
the screw far enough to allow the blue wire to be
removed from the terminal.
4110390
1.
2.
OU0780
4
5
5
MU0650
6
7
8
9
10
11
MU6560
14
15
16
18
17
12
13
MU6580
17
19
20
21