Konica Minolta Printgroove - Manual (Page 143)

Printgroove POD Queue Tools 5
Printgroove POD Queue 5-72
5.7.1 Printer Monitor: Setting Options
Most of the information displayed in the Printer Monitor is static and provides
information about the printer. A description of each Setting Option follows.
Options
In order for Printgroove POD Queue to properly implement [Auto Mode] or
[Selection] panel recommends, it must understand which finishing options
are installed for each printer. From the [Options] panel you must install all
available finishing options for all discovered and manually added printers.
1
Double-click on a printer icon in the Destination panel to open the
Printer Monitor. By default, the [Options] screen is open.
2
All supported finishing options are listed in the [Available Options] field.
Select an option from the field and click the [Add] button. The option
moves to the [Installed Options] field. Repeat until all required options
are installed.
3
To uninstall an option, select it in the [Installed Options] field and click
the [Remove] button. The option is moved to the [Available Options]
field.
2
Note
Printgroove POD Queue uses SNMP or JDF to detect the installed op-
tions automatically. Because of device limitations, not all options may be
detected. You may need to confirm that the list of Installed Options on