Videotec DCT - Manual (Page 91)

6.5 ERNITEC SATURN Dome
6.5.1 Materials and reference documents
Ernitec Saturn Dome.
ICU Installation Instruction, Manual No.3040-00014, Rev.980220.
6.5.2 Connecting the hardware to the dome
DCT RJjack1 DOME Connection diagram
RS485A white Rx+
RS485B yellow Rx-
6.5.3 Configuration
The dome is mainly configured by On Screen Menu
Some parameters can be configured by inserting a special code.
For all dome configuration operations it is necessary to enable the "Setup telemetry" FUNCTION (see §
4.2.4.5 - Functions, page 35).
Follow the general procedure to connect the dome directly to the keyboard and a monitor to the dome video
OUT (see § 6.19 - Operating procedure for setting a dome/receiver, page 137).
Go to the OSM configuration page (see § 6.1.5 - Layout of the configuration menus, page 76) where it is
possible to make the settings for the various parameters.
ENTER PROGRAMMING
To enter the dome OSM.
UP/DOWN ARROWS
To move within the dome menus and change the
values.
LEFT/RIGHT ARROWS
Correspond to the “Previous” and “Next” keys as
indicated in the dome handbook.
ENTER MENU
To enter the submenus and confirm the data change.
6.5.4 Autopan, Aux, Focus, Iris
All these functions can be loaded by pressing the specific keys in the control menu area of the Main menu (see
§ 4.4 – Control menu area, page 45).
Refer to § 9.1 – Functions assigned to the most common graphics keys, page 164 e § 9.2.1 – Dome, page 165
to check which functions are available for the dome.
Page 89 of 176 MNVADCT03_0716