Videotec DCT - Manual (Page 35)

4.2.4.3 External DVR/MUX cameras
This menu is used to enable the cameras (managed by one of the 16 DVR/MUX that can be connected in
cascade to a matrix) that can be selected from the keyboard.
It is possible to manage 100 accepted camera values for each of the 16 DVR/MUX.
Activated camera status is indicated by the presence of the letter A or B, to show that the camera is connected
to telemetry A or B.
WARNING: If the camera present in the system is fixed (not equipped with Pan & Tilt
movement), to operate it you need to associate it with one of the two telemetries (A or B)
1. Address of selected DVR or MUX
Exit menu key
Key for entering menu to edit individual
cameras
Cursor shift keys
Keys for increasing/decreasing DVR/MUX
Keys for activating/deactivating all the cameras on the page
Keys for activating/deactivating all the cameras on the row indicated by the cursor
Keys for selecting telemetry A/B
Use the or keys to select the connector to which the cameras are connected and proceed to activate
the cameras using the row or page keys. To activate/deactivate individual cameras press the “ ent ”key.
When connecting with devices other than the SW128/16 or 128/16 ENEO EKR matrix, setting
monitor and camera numbers above the physical limits of the connected devices will be accepted
but will have no effect on the devices themselves.
4.2.4.3.1 Single DVR/MUX cameras
Position the cursor on the number of the camera to be modified. Press the “ ent ” key. The letter corresponding
to the number will change showing either the letter “A” (telemetry A), “B” (telemetry B) or “
|
” (camera
disabled).
Exit menu key
Edit camera key
Cursor shift keys
Page 33 of 176 MNVADCT03_0716
1