Videotec DCT - Manual (Page 54)

5.1.1.2 DVR or MUX connected to video connector
With this type of connection the keyboard manages the video units connected to it in a variety of ways,
depending on the VIDEO protocol in use.
5.1.1.2.1 “SANYO DVR/MU” VIDEO protocol
It is possible to connect both DVR's and MUX's simultaneously to the VIDEO line and the keyboard will
display the function keys corresponding to the selected video unit. There is a special key for passing from
DVR to MUX and vice versa.
Controlling a Sanyo MUX Controlling a Sanyo DVR
1. Specific control area for the selected MUX
2. Video control area 1. Specific control area for the selected DVR
2. Video control area
To transfer to control of a DVR/MUX connected to the network, if present
To select the active MUX/DVR
To select the active camera
WARNING
• With this type of configuration every DVR and MUX connected to the network should have a
different address (for example, it is impossible to select MUX No. 1 and later on DVR No. 1).
• It is only possible to load DVR's/MUX's with previously accepted values (see § 4.2.4.2.3 - DVR
or Multiplexer (direct connection with DVR or MUX), page 32 and § 4.2.4.1.4 - Single
cameras connected to DVR or MUX, page 30).
Page 52 of 176 MNVADCT03_0716
2
1
2
1