Videotec DCT User Manual
Page 157

•
Select a monitor or the DVR or MUX number.
•
Select the camera
•
Send a direct command to telemetry (i.e. a control that does not imply video switching even if the camera
is assigned to a monitor or to a DVR/MUX).
Example: if you are controlling dome No. 3 and you send a direct Scan command to the Telemetry of
dome No. 5, the latter will go to the required position without this being shown on the monitor, because in
this case there will not be transmission of a video switching control.
•
Start a matrix switching sequence.
•
Reset the matrix.
•
Load the OSD for a dome.
•
Display the numeric keypad for inserting Special codes.
•
Assign the key with display of the General System Information page.
•
Assign the key with particular functions for DVR/MUX control.
To do this it is necessary to select a DVR or MUX so that the DVR/MUX Functions checkbox will appear.
When this is shown the part of the window corresponding to Matrix/DVR-MUX will resemble the
following illustration.
The
key loads another small
window containing the list of all
DVR/MUX's that it is possible to
control,
along
with
the
respective key grids. A simple
click of the left key of the mouse
on the icon of interest will assign
that function to the map key.
•
Display the numeric keypads for inserting the Camera/Monitor/Video unit number; these are the same as
the first six types described in § 6.1.2.4 - Numeric keypads with load keys, page 75.
7.4.3.9.2
“Focus/Iris” Controls
The controls that can be loaded from this section are used to control the camera lenses. The default setting is
Not enabled.
7.4.3.9.3
“Aux” Controls
The controls (default = Off) that can be loaded from this section are used to control the specific auxiliary ports
(by entering their identification number) or to assign to the key the function for displaying the numeric
keypad, in order to achieve greater flexibility
7.4.3.9.4
“Jump page”
Controls
The controls (default = Off) that can be loaded from this section are used to pass to another map or return to
the keyboard main menu (and hence to exit the GRAPHICS environment).
If a Password level has been selected and the corresponding password has been enabled previously (see §
4.2.5 - Password, page 37), the system will ask you to enter it every time you press this key.
WARNING
The system monitors the jump page sequence and informs the user if some of the maps do not
have a return key.
Page 155 of 176
MNVADCT03_0716