Videotec DCT - Manual (Page 120)

6.13 SANYO Dome
6.13.1 Materials and reference documents
Sanyo VCC-9300P, VCC-9400P dome.
Security Serial Protocol (SSP) Specifications Ver. 1.14 Rev. 2003/08/18.
High Speed Serial Protocol (HSSP) Specifications Ver. 1.01 Rev. 2004/03/10.
6.13.2 Connecting the hardware tothe dome
DCT RJjack1 DOME Connection diagram
RS485A white A(+)
GND red GND
RS485B yellow B(-)
6.13.3 Configuration
The dome is mainly configured by On Screen Menu
Some parameters can be configured by inserting a special code.
For all dome configuration operations it is necessary to enable the "Setup telemetry" FUNCTION (see §
4.2.4.5 - Functions, page 35).
Follow the general procedure to connect the dome directly to the keyboard and a monitor to the dome video
OUT (see § 6.19 - Operating procedure for setting a dome/receiver, page 137).
Go to the OSM configuration page (see § 6.1.5 - Layout of the configuration menus, page 76) where it is
possible to make the settings for the various parameters.
ENTER PROGRAMMING
To enter the dome OSM.
CONFIRM KEY
To confirm the operation.
UP/DOWN ARROWS
To move within the dome OSM.
LEFT/RIGHT ARROWS
To change the value indicated by the cursor.
6.13.4 Autopan, Aux, Focus, Iris
All these functions can be loaded by pressing the specific keys in the control menu area of the Main menu (see
§ 4.4 – Control menu area, page 45).
Refer to § 9.1 – Functions assigned to the most common graphics keys, page 164 and § 9.2.1 – Dome, page
165 to check which functions are available for the dome.
Page 118 of 176 MNVADCT03_0716