Videotec DCT User Manual
Page 103

6.9.5.1
Setup PATROL and Clear PATROL
With the PATROL function the dome is able to reach a maximum of 130 Preset positions; when it reaches the
last position the sequence is repeated from the beginning.
There are 6 possible PATROL paths:
PATROL 0: the sequence goes to all the stored Preset positions; the user cannot change it.
PATROL 3: the sequence visits all the stored Preset positions at random; the user cannot change it.
PATROL 1, 2, 4, 5: these sequences can be defined by the user when the various Preset positions are
stored (see § 6.9.6.1 - Mark Mercer PRESET, page 103).
Press the
key to enter the “CLEAR PATROL SEQUENCE” page, where one or more of the previously
defined PATROL sequences can be deleted.
Procedure for deleting a
PATROL sequence
position the cursor on the PATROL to be removed and press the “
ent
” key.
Press the ESC key to return to the PATROL page.
WARNING
If you delete a PATROL sequence you will also delete the corresponding One Pass PATROL.
PATROL Nos. 0 and 3 cannot be changed by the user and therefore cannot be deleted.
Page 101 of 176
MNVADCT03_0716