Videotec DCT - Manual (Page 37)

4.2.4.5 Functions
Position the cursor on the function to be enabled/disabled and press the “ ent ” key. If the function was
deactivated it will be activated and vice versa.
Enabling/disabling these functions directly affects the screen display of the commands in the
various menus. For example, if the “AUTOPAN/SCAN/PATROL” function is not enabled the
operator will not be allowed to enter the corresponding menus and there will be a message saying
“Function disabled”.
FUNCTION DESCRIPTION
Mtx/DVR/MUX Setup Enables/disables the keyboard for editing the parameters (loaded using the
PROG key) of the matrixes, DVR's or MUX's connected to it.
Telemetry Setup Enables/disables the keyboard for editing the parameters (loaded using the
PROG key) of the domes or receivers connected to it.
Autopan/Scan/Patrol Enables/disables the keyboard for sending automatic movement commands to
the dome or receiver.
Joystick Enables/disables the keyboard for sending movement controls arriving from the
joystick.
Camera Up/Dw Enables/disables sending commands to move up and down the cameras (only for
matrixes).
Address change Enables/disables modification of the association between camera and
dome/receiver address.
Mon/DVR/MUX change Enables/disables monitor, DVR, MUX selection.
Zoom/Focus/Iris Enables/disables the keyboard for sending ZOOM, FOCUS and IRIS controls.
Aux Enables/disables the option to modify the auxiliary relays of the dome/receiver
Wiper/Washer Enables/disables the WIPER and WASHER functions associated with the
dome/receiver.
GRAPH. background Enables/disables display of keys for entering the GRAPHICS environment
(Maps) loaded into the device.
GRAPH. Envir. Only Enables/disables direct entry into the GRAPHICS environment when the
keyboard is switched on (i.e. without having to use keys to load it from the main
menu).
If the “GRAPHICS Environment Only” function is enabled this automatically forces enabling of
the “GRAPHICS environment” function.
Page 35 of 176 MNVADCT03_0716