Videotec DCT - Manual (Page 118)

6.12 SAMSUNG Dome
6.12.1 Materials and reference documents
Samsung SCC-641P, SCC-643P Dome.
Samsung Protocol.
6.12.2 Connecting the hardware to the dome
DCT RJjack1
DOME
SCC-641P SCC-643P
Connection diagram
RS485A white Txd+ Rxd+
RS485B yellow Txd- Rxd-
Configure the SCC-643 dome in FULL DUPLEX mode.
If the system requires it, it is possible to configure the dome in HALF DUPLEX mode; connection
is identical to that of the SCC64-1P Dome, for poles Txd+ and Txd-.
6.12.3 Configuration
The dome is mainly configured by On Screen Menu
For all dome configuration operations it is necessary to enable the "Setup telemetry" FUNCTION (see §
4.2.4.5 - Functions, page 35).
Follow the general procedure to connect the dome directly to the keyboard and a monitor to the dome video
OUT (see § 6.19 - Operating procedure for setting a dome/receiver, page 137).
Go to the OSM configuration page (see § 6.1.5 - Layout of the configuration menus, page 76) where it is
possible to make the settings for the various parameters.
ENTER PROGRAMMING
To enter the dome OSM.
EXIT PROGRAMMING
To exit the OSM.
FOCUS / IRIS
To carry out the related function at the PRESET
position setting stage.
KEY 5
To be used as indicated in the dome handbook.
ENTER MENU
To enter the submenus and confirm the changed
settings.
To increase/decrease the values within the menu use the joystick..
6.12.4 Autopan, Aux, Focus, Iris
All these functions can be loaded by pressing the specific keys in the control menu area of the Main menu (see
§ 4.4 – Control menu area, page 45).
Refer to § 9.1 – Functions assigned to the most common graphics keys, page 164 and § 9.2.1 – Dome, page
165 to check which functions are available for the dome.
Page 116 of 176 MNVADCT03_0716