Videotec DCT - Manual (Page 41)

4.2.6.2 Buzz er/Display
Parameter Description
Key pressed Used to set the buzzer volume when the keys are pressed. There are three values: OFF (no
sound) MIN (minimum)and MAX (maximum).
Joystick Enables/disables a small beep every time the joystick is moved
Serial error Enables/disables the buzzer if there is a serial communication error
Matrix alarm Enables/disables the buzzer if there is a matrix alarm
Power saving Enables/disables timed power-saving (after one minute of inactivity) for the backlit
display. To reactivate the display just press any key.
4.2.6.3 Joystick
In this page it is possible to calibrate the joystick; the cursor gives step-by-step instructions for the operations
to be carried out.
Follow the procedure, through all the stages:
1. Release the joystick and press the ”
ent ” key.
2. Move the joystick to the right as far as possible, keep it in this position and press the “ ent ” key.
3. Move the joystick to the left as far as possible, keep it in this position and press the “ ent ” key
4. Move the joystick up as far as possible, keep it in this position and press the “ ent ” key.
5. Move the joystick down as far as possible, keep it in this position and press the “ ent ” key.
6. Turn the zoom knob as far to the left as possible, keep it in this position and press the “ ent ” key .
7. Turn the zoom knob as far to the right as possible, keep it in this position and press the “ ent ” key .
WARNING
If a mistake is made during calibration, the operation can be either completely or partially
repeated, taking care to position the cursor on the required calibration stage using the up/down
keys.
Page 39 of 176 MNVADCT03_0716